Load64

Hey Remzi.

Recieved the adapter the other day and had a couple of teething troubles to begin with but seem to be getting good results now both backing up and recording! 

I've found with my current setup that leaving the taps I create from wavs as-is is working better than running and optimising through finaltap/tapclean. Most of the time both programs don't recognise the files and they appear as very poor copies but running them unoptimised through winvice is working.

I pretty much always have the audio 'pops' at peast once per tape but it doesn't seem to affect the outcome.

Thanks very much for making this. Finally can make backups and copies.

While testing the BT receiver I found the problem : A small droplet of solder lodged between 2 smd capacitors on the receiver.

I can now confirm this connection is working, but loading from tape is very unreliable.

Some games load like 90% of the times, while other never load correctly.
I am testing with .tap files from privat.bahnhof.se, maybe their collection is unreliable ?

Thanks Remzi for answer.

My BLUEtooth datassette is finally working :



 

I managed to get good signal from that pin in the photo using a 100nf capacitor.You might also use a 100k resistor instead.

Hello all,

I have this exact same PCB in my datassette, I tried connecting a bluetooth receiver's output  to the "left" (with 100nf cap) and "GND" points mentionned in quoted post.

Sadly, it doesn't seem to work.
I use tapdancer to send the data from my mobile, the bluetooth adapter works fine.
the C64 doesn't find anything when i send data through tapdancer.

Here's a picture of what I did :





1 - At first I forgot the 100nf cap, may I have broke something ?
2 - Does it matter what kind of cap is used ? electrolytic/film/tantalum... etc.
3 - any other idea ?  Do you guys see anything wrong in my setup ?
4 - Anyone else tested this spot labeled "left" connection with success ?

Tape still seems to work but I have no cassette to test it with.

These are the steps,if you want to be able to hear the datastream from the datasette.


1.Press Windows Key and R to open RUN window and type mmsys.cpl



Or right click on the speaker icon and select recording devices.


Double click USB microphone,go to Listen tab and tick the Listen to this device box.
Go to playback devices and set your own speakers as default.

With this configuration,you can listen to whatever is coming from the tape.
DO NOT use listen to this device feature if you are going to record a game to tape.You have to disable it.

Hello

In the very first post there is this part 'LINE IN for RECORDING' (This mod is for recording games to cassette tapes.) and this is what I'm after. Just happens that my only Datassette with that board doesn't work, all I have is two of those MODE 1530 boards which can seen on the page 2 in post number 6 (Wakd21).

Now, anyone know where to make the connections to use that kind of Datassette for recording? Almost everything in this thread is about connecting to pins to be able to load games directly from a phone (or some other audio source) but I'm looking to record a tape.