Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kenobi

Pages: [1]
1
Other MODs / Re: Unlock Your Datasette
« on: April 14, 2020, 07:54:46 PM »
Hi Remzi,
so mod is working now for me but still persist some issue. Sometimes the game was loaded fine, sometimes not. I found out that it is dependent on phone type and on sound quality of device maybe. Look at this video please and tell me if you think that signal is good. I saw some artefacts or noise. Can it be problem? What kind of adjustment can fix it? But I must thank you again, this is good step forward :-)



2
Other MODs / Re: Unlock Your Datasette
« on: April 09, 2020, 05:59:52 PM »
Oh, it's great, thank you very much. I will try to get some 100nF capacitor but due Coronavirus emergency state in our country it is hard now. Most shops are closed. Thank's again I will post a result when I'm done.

3
Other MODs / Re: Unlock Your Datasette
« on: April 07, 2020, 12:15:48 AM »
I'm not sure if is in the opposite orientation. I did make a better photos and do some "investigation" :-). Hope it's right but with schematics of opamp and his function I'm not sure yet. Can you look at this please and tell me if your previous suggestion is right? Thank you.




4
Other MODs / Re: Unlock Your Datasette
« on: April 04, 2020, 03:14:42 PM »
Hi Remzi, thank you.
I tried as you adviced but nothing signal arrived to C64. My cheap multimeter at range 200V AC was able to get 3,4V at this pin before I solder cable with 3,5mm jack. I don't know if it is proper way to get relevant data with this type of multimeter due it's AC voltage with another sinus than 50Hz. Have you any idea how to solve it? Thank you for reply, Martin.



5
Other MODs / Re: Unlock Your Datasette
« on: April 02, 2020, 09:16:27 PM »
Hello, first of all, thanks for your excellent work for Commodore crew. I have my own one almost 25 yers :-) I want to try this mod for my Noris DR-1535 but I haven't skill to read schematics. I found on another forum your post with picture of DR-1535 board (attached bellow), it's the same as mine. Could you help me please with solution of soldering right ones pins of the board? Thank you very much. Martin.






Pages: [1]